How To Use The Accessories . En; Important Application Instructions - Kärcher SC 1133 Originalbetriebsanleitung

Refilling Water
Water needs to be filled into the boiler, if the
steam volume decreases during work and no
more steam is emitted in the end.
Note: The safety lock cannot be opened as
long as slight pressure remains in the boiler.

Push the steam switch until steam dis-
charge stops. Now, the boiler of the appli-
ance is unpressurized.

Press the OFF switch to turn off the appli-
ance.

Disconnect the mains plug from the socket.

Remove the safety cap from the device.
Danger
A residual amount of steam may be emitted
when you open the safety lock. Be careful
when opening the safety lock, there is a risk of
scalding.

Fill the boiler with a maximum of 1 liters of
fresh tap water.
Danger
If the boiler is hot, there is the risk of scalding
as the water may splash back during the filling
process! Do not fill any detergents or other ad-
ditives into the boiler!

Screw the safety cap back onto the device.
 Insert the mains plug into a socket.

Press the ON switch to turn on the appli-
ance.

The orange indicator lamp goes out after
approximately 8 minutes.
The steam cleaner is ready to use.
Turning Off the Appliance

Press the OFF switch to turn off the appli-
ance.
 Disconnect the mains plug from the socket.

Press the cover of the appliance connec-
tor to the bottom and disconnect the
steam plug from the appliance connector.
Storing the Appliance

Illustration
Put the extension pipes into the large ac-
–
cessory compartments.
Insert the manual nozzle and detail nozzle
–
onto each extension pipe.
Put the round brush into the medium
–
acessory compartments.
Hook the floor nozzle into the parking po-
–
sition.
Wrap the steam hose around the exten-
–
sion pipes and insert the steam pistol into
the floor nozzle.
How to Use the Accessories

Important application instructions

Cleaning floor surfaces
It is recommended to sweep or vacuum the
floor prior to using the steam cleaner. This
way, the floor is already cleared of dirt/loose
particles prior to the wet cleaning.
Refreshing textiles
Prior to treatment with the steam cleaner, al-
ways check the reaction of the textiles in an in-
conspicuous location: Steam at first, then let dry
and then check for colour or shape changes.
Cleaning of Coated or Lacquered Surfaces
When cleaning painted or plastic-coated sur-
faces, as found on kitchen and living room fur-
niture, doors, parquet; wax, furniture polish,
plastic surfaces or paint can come loose or
stains can be created. When cleaning these
surfaces, briefly steam a cloth and wipe the
surfaces with it.
Caution
Never direct the steam jet at glued edges as
the edge band may loosen. Do not use the
steam cleaner on unsealed wooden or par-
quet floors.
Cleaning of Glass
In case of low outside temperatures, especial-
ly in the winter, warm up the window pane by
slightly steaming the entire glass surface.
This will prevent tensions on the surface
which might lead to glass breakage.
Then clean the window surface with the hand
nozzle and attachment. Use a squeegee to
remove the water or wipe the surfaces dry.
– 9
EN 19