The SKSCEM1 runs an initialisation phase
during which the operating control lamp
flashes red and green.
Afterwards, the module begins normal
operation and indicates the measured val
ues of the sensors connected.
Adjustment channel SA
Adjustment range:
1 ... 3
Factory setting: 1
If several heating circuit modules are
used in the same system, make sure the
SA communication addresses are correct
ly assigned. The subaddress must not be
configured in the main controller but in
the SKSCEM1 menu directly.
34
Never use the same communication
address for more than one device!
Î open the housing
Î select the channel SA with + and
Î press the SET button, „SEt" flashes on
the display
Î select a unique address with + and
Î confirm the selection by pressing the
SET button
ATTENTION: Only heating circuit mod
ules of the same model/software versions
can be connected to a SKSC3+ controller!
GB