Electrical Connection - Scheppach Hbs20 Original Bedienungsanleitung

10.3 Freehand cuts (Fig. 19)
• One of the most important features of a band saw is the ease with
which it can cut curves and radii.
• Lower the saw band guide (5) onto the workpiece (see 8.5).
• Switch on the saw.
• Press the workpiece firmly onto the saw bench (7) and slowly slide into
the bandsaw blade (21).
• In many cases it is helpful to roughly saw curves and corners approx-
imately 6 mm from the line.
• If it is necessary to saw curves that are too tight for the saw band used,
auxiliary cuts must be sawn up to the front face of the curve, so that
these fall off as wood waste when the final radius is sawn.

11. Electrical connection

The electrical motor installed is connected and ready for operation. The
connection complies with the applicable VDE and DIN provisions.
The customer's mains connection as well as the extension cable used
must also comply with these regulations.
Important information
In the event of an overloading the motor will switch itself off. After a cool-
down period (time varies) the motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through win-
dows or doors.
• Kinks where the connection cable has been improperly fastened or
routed.
• Places where the connection cables have been cut due to being driven
over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
64 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58