Transporting The Machine; Electrical Connection - Scheppach Temver St700C Originalbetriebsanleitung

10. Transporting the machine

Swivel frame lock
• To transport the rocking log saw, latch the swivel
lock in position (1).
• Transport the rocking log saw by the handle (2).
• When transporting the rocking log saw with pet-
rol engine, insert the transport handle (3) through
2 loops and, for safety, slightly turn it, and lift and
transport it using the transport handle.
• Bring a second person for transport.
1
11. m Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the
applicable VDE and DIN provisions. The customer's
mains power connection as well as the extension
lead used must also comply with these regulations
and the local regulations. Check the electrical con-
nection cables for damage regularly. Ensure that the
connection cables are disconnected from electrical
power when checking for damage.Electrical connec-
tion cables must comply with the applicable VDE and
DIN provisions. Only use connection cables with the
marking „H 07 RN". The printing of the type designa-
tion on the cable is mandatory.
Damaged electrical connection cables
The insulation on electrical connection cables is
often damaged.
Causes are:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cables have been
improperly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to insulation
damage!
m AC motor
• The mains voltage must be 220÷240 V/50 Hz.
• Extension leads up to 25 m long must have a mini-
mum cross section of 1.5 mm², and over 25 m long
must have a minimum cross section of 2.5 mm².
• The mains power connection is protected with a
16A slow-blow fuse.
• The RCD circuit breaker must have a 30 mA trip
rating.
When connecting to the mains or in the event of the
machine being moved to another location, the turn-
ing direction must be checked. It may be necessary
to change the polarity.
Turn the pole changing device in the device connec-
tor.
Motor braking device
The brake brakes the drive motor of the sawing shaft
2
within 10 s.
The electric braking is interrupted after max. 14 s.
If the braking process takes longer than 10 s, the
machine must no longer be operated because the
brake is defective. It is essential to disconnect the
machine from the power supply.
Only a qualified electrician may be assigned with
troubleshooting.
Operating mode / duty cycle
The electric motor is designed for operating mode
S2 - 15 %.
S2 = Continuous operation with intermittent load
15% = Based on 10 min: 2 min. load; 8 min. idle
mode.
If the engine is overloaded, it switches off automati-
cally because a thermostat protects the motor from
overloading. After a cool-down period (time varies)
the motor can be switched back on again.
Electrical connection test
• Switch on the machine at the operating switch; the
sawing shaft starts running.
m Connections and repair work on the electrical
equipment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Engine manufacturer; engine type
• Type of current for the motor
• Machine data - type plate
• Electrical control data
When returning the engine always send in the
complete drive unit with electrical control. m
m Petrol engine
Only valid for petrol variants
Engine oil
GB | 21