Scheppach HBS20 Original Bedienungsanleitung Seite 58

8.4.4 Adjusting the bottom guide pins (46) (Fig. 7+8)
• Disassemble saw table (7)
• Undo screw for bottom retainer (43) (Allen key, size 5)
• Move bottom retainer (47), bottom guide pins (46), until the front edge
of the bottom guide pins (46) is approx. 1 mm behind the tooth base of
the saw band.
• Retighten screw for bottom retainer (43).
• ATTENTION! The saw band will be unusable if the teeth touch the
guide pins with the saw band running.
• Undo Allen screws for bottom guide pins (45).
• Slide the two bottom guide pins (46) sufficiently far in the direction of
the saw band that the distance between the guide pins (46) and band-
saw blade (21) is max. 0.5 mm. (Saw band must not jam)
• Retighten Allen screws for bottom guide pins (45).
• Turn the bottom saw band roller (8) a few times in a clockwise direc-
tion.
• Check the setting of the bottom guide pins (46) again and adjust if
necessary.
• If necessary, adjust the bottom support bearing (42) (8.4.2).
8.5 Adjusting the top saw band guide (5) (Fig. 9)
• Undo locking handle for saw band guide (23).
• Turn the adjustment handle for the saw band guide (22) to lower the
saw band guide (5) as closely as possible (distance approx. 2-3 mm)
over the material to be cut.
• Retighten locking handle (23).
• Check the setting before every cutting process and adjust if neces-
sary.
8.6 Adjusting the saw table (7) to 90° (Fig. 10+11)
• Set the top saw blade guide (5) fully upwards.
• Undo locking handle (20) and wing nut (31) (Fig. 2).
• Place the angle bracket between the bandsaw blade (21) and saw ta-
ble (7). Angle bracket not included in the scope of supply.
58 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58