Attachment; Assembly Tools - Scheppach Hbs20 Original Bedienungsanleitung

8. Attachment

ATTENTION!
Before all maintenance, set-up and assembly work on the band saw,
unplug the mains plug.

Assembly tools

1 Open-ended spanner, size 10/13
1 Allen key, size 3
1 Allen key, size 4
1 Allen key, size 5
1 Screwdriver
The saw table is not assembled for packaging reasons.
8.1 Assembling the saw table (Fig. 2-4)
• Remove the wing nut (31), the locking handle (20), the two washers
and the clamping plate (32). (Fig. 2)
• Remove the two knurled nuts (33), the U-reinforcement (34) and the
two countersunk screws M6x16 from the saw table. (Fig. 3)
• Guide the saw table (7) over the bandsaw blade (21). Fasten it to the
two screws on the machine frame with the plate (32), the two washers,
the wing nut (31) and the locking handle (20). (Fig. 4)
• Fasten the U-reinforcement (34) to the front side of the saw table with
2 countersunk screws M6x16 and 2 knurled nuts (33). (Fig. 3)
8.2 Tensioning the saw band (Fig. 1a)
• ATTENTION! If the saw is at a standstill for an extended period the
saw band tension must be relieved, i.e. before switching the saw on it
is necessary to check the saw blade tension.
• Turn the clamping screw (1) clockwise to tension the bandsaw blade
(21). The correct tension of the saw band can be determined by press-
ing the finger laterally against the saw band, roughly centrally between
the two saw band rollers (2+8). The bandsaw blade (21) should only
depress slightly (approx. 1-2 mm) here.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 55