Operation - Scheppach Hbs20 Original Bedienungsanleitung

• Place the new bandsaw blade (21) centrally on both saw band rollers
(2+8). The teeth of the bandsaw blade (21) must point downwards in
the direction of the saw table (Fig. 6).
• Tension the bandsaw blade (21) (see 8.2)
• Close the side cover (11) again.
• Re-install the U-reinforcement (34).
8.9 Replacing the table insert (Fig. 13)
• In case of wear or damage, the table insert (6) must be replaced; oth-
erwise there is an increased risk of injury.
• Remove the worn table insert (6) by lifting it up and out.
• Installation of the new table insert takes place in reverse order.
8.10 Extraction nozzle (Fig. 1b)
• The band saw is equipped with an extraction nozzle (19) Ø 40 mm for
chips.
• Only operate the device with a suitable extraction system. Check and
clean the suction channels at regular intervals.
8.11 Push Stick retainer (Fig. 12)
• The Push Stick retainer (48) is pre-mounted on the machine frame. If
unused, the Push stick (26) must always be stowed in the Push Stick
retainer.

9. Operation

9.1 On/Off switch (12) (Fig. 15)
• To turn the machine on, press the green button „I".
• To turn the machine off again, press the red button „0".
• The band saw is equipped with an undervoltage switch. With a power
failure, the band saw must be switched back on again.
9.2 Parallel stop (Fig. 16)
• Press the clamping bar (25) of the parallel stop (24) upwards
60 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58