Scheppach HBS20 Original Bedienungsanleitung Seite 59

• Tilt the saw table (7) by turning, until the angle to the bandsaw blade
(21) is precisely 90°. If the saw table is already on the screw (49) and a
90° angle cannot be set, undo the nut (50) and shorten the screw (49)
by turning in a clockwise direction.
• Retighten the locking handle (20) and wing nut (31).
• Also undo the nut (50).
• Adjust the screw (49) sufficiently that the saw table touches the under-
side.
• Retighten the nut (50) to fix the screw (49) in position.
8.7 Which saw band to use
The saw band supplied in the band saw is intended for universal use. The
following criteria should be considered when selecting the saw band:
• It is possible to cut tighter radii with a narrow saw band than with a
wide saw band.
• A wide saw band is used if a straight cut is required. This is impor-
tant in particular when cutting wood. The saw band has a tendency to
follow the wood grain and therefore deviates easily from the desired
cutting line.
• Fine-toothed saw bands cut more smoothly, but also more slowly than
coarse saw bands.
Attention: Never use bent or torn saw bands!
8.8 Replacing the saw band (Fig. 1a+1b+14)
• Set the saw band guide (5) at approx. half height between the saw
table (7) and machine frame (15).
• Undo the cover locking mechanisms (10) and open the side covers
(11).
• Remove U-reinforcement (34) as described in 8.1.
• Relieve the bandsaw blade (21) tension by turning the clamping screw
(1) anti-clockwise.
• Remove the bandsaw blade (21) from the saw band rollers (2+8) and
through the slot in the saw table (7).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 59