Checking The Spark Plug - Scheppach Sy-Mb815 Originalbetriebsanleitung

18.12.5 ,QVSHFWLRQ DQG FOHDQLQJ RI WKH DLU ¿ O WHU
element
1. Open the bonnet and remove the dust cover.
2. Remove the outer element, clean the element and
the inside of the housing and reassemble.
3. When reassembling, ensure that the dust cover is
fitted with the UP mark (arrow) pointing upwards.
Do not remove the inner element.
Important!
If the machine is used in extremely dusty are-
DV WKH DLU ¿ O WHU HOHPHQW PXVW EH LQVSHFWHG DQG
FOHDQHGPRUHIUHTXHQWO \ WKDQWKHVSHFL ¿ H GPDLQ
tenance intervals.
Important!
7KHDLU ¿ O WHUKDVDGU \ HOHPHQWNHHSLWIUHHRIRLO
Important!
'RQRWUXQWKHHQJLQHZLWKRXWWKHDLU¿ O WHU
18.12.6 0DLQWHQDQFHRIWKHDLU¿ O WHU
m Caution
Wear eye protection!
Cleaning with compressed air
The pressure of the compressed air must be below
205 kPa (2.1 kg/cm) and the cartridge must be blown
clean from the inside to the outside until the dust de-
posits have been completely removed.
-
Important!
,I WKH DLU LQWDNH LV VWLOO QRW VXˆ F LHQW RU WKH FRO
our of the exhaust gases is abnormal even after
FOHDQLQJWKHDLU¿ O WHUHOHPHQWPXVWEHUHSODFHG

18.12.7 Checking the spark plug

Use the special spark plug spanner to remove the
spark plug and check whether there are any carbon
deposits on the spark plug needle. In this case, re-
move the carbon deposits. Replace the spark plug if
it is defective.
www.scheppach.com
-
GB | 95