EN
6. After 20 minutes of one self-cleaning program completing, pull out the drain pipe of the water
tank, drain the cleaning solution down to the lower ice storage bin. Shake the unit slightly to
drain out all of the cleaning solution completely. Then install back the drain pipe to the slot
of the water tank.
7. Repeat steps 4-6 to clean the ice making assembly system again.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands.
Carefully read the material safety instructions on the container of the ice machine
cleaner.
8. Then open the water faucet of the main water supply, Let the water flow in the unit. And
press the "TIMER/CLEAN" button on control panel for more than 5 seconds, to enter the
self-Cleaning program. Same as above explanation, the water pump runs for 8 minutes and
stops for 3 minutes, one cycle, again one cycle. The total duration time is 20 minutes for
one self-cleaning program.
During this process, the "
window will indicate the left time. Through this process, it will rinse the water dividing pipe,
evaporator, water pump, silicone pipe, and water tank, etc.
9. After one self-cleaning program complete, then pull out the drain pipe of the water tank,
drain the cleaning solution down to the lower ice storage bin, also shake the unit slightly to
drain out all of the water completely. Then install back the drain pipe to the water tank slot
tightly.
10. Repeat the step 8-9 again for 2 times.
11. Following the above program to clean the ice storage bin.
12. Then this special cleaning program finish, you can return to the regular ice making
mode. And suggest to discard the first batch of ice cube.
Cleaning Suggestion
1) DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself per each
day. At the end of every day, rinse the ice shovel and wipe the both sides of the door with
a clean cloth.
2) SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the
evaporator are to be cleaned by yourself semi-monthly according to interior cleaning
program.
3) SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water
tank, door, evaporator, water pump, silicone tube, water dividing pipe, etc. should be
WARNING
" symbol will always be on during this period, and the digit
23