Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove all packaging. Then check all the accessories are included. If any parts are
missing, please contact our customer service.
2. Keep the appliance away from direct sunlight and other sources of heat (i.e. stove,
furnace, radiator). Place the ice maker on an even surface. Allow at least six inches of
space between the back and sides of the ice maker and the wall.
3. Allow one hour for the refrigerant liquid to settle before plugging in the ice maker.
4. Position the appliance so the plug is accessible.
WARNING: Fill with drinking water only.
CONNTCTING YOUR ICE MAKER
* Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this
appliance is equipped with a three-prong plug that aligns with standard three-prong
wall outlets to reduce the risk of an electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Under
no circumstances, do not cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed towards a
certified electrician.
3. This appliance requires a standard 220-240volt, 50Hz electrical outlet with three-
prong ground.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using the ice maker, ensure it is cleaned thoroughly.
1. Unplug the unit before cleaning or maintenance.
2. Clean the inside with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the
drain cap on the side.
4. Clean the outside of the unit regularly with a mild detergent solution and warm water.
5. Dry the inside and outside with a soft cloth.
6. When the machine is off, open the water drained cap to drain water from the reservoir.
WARNING: Fill with drinking water only.
Note: Blowing gas inside the unit is flammable, disposal of these materials must be in
accordance with national regulations.
!
5
Werbung
