Correct Disposal Of This Product - Homcom 800-254V70 Bedienungsanleitung

EN
Water pump work, but
no water flow out from
the water dividing pipe
Water circulation pump
doesn't work
The transparency of the
ice cube is not very
good.
Ice cube shape is
irregular.
Ice cube is very thin.
Ice cube is too thick.
"ICE-FULL" symbol is
on.
Ice making cycle is
normal, but there is no
ice cube produced.

Correct Disposal of this product

The little holes on the water
dividing pipe are blocked.
Some special substance in water
tank blocks the pump blade.
Water quality is bad.
Water quality is not good or the
water tank is very dirty.
The little holes on the water
dividing pipe are some blocked.
Ambient temperature is too high.
Air circulation around the unit is
not good.
Ambient temperature is too low.
The ice storage bin is full of the
ice cube.
The temperature of ambient, or
water in water tank is too high.
Refrigerant leakage, E2 error
code display.
Cooling system tube is clogged.
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health systems or contact the retailer where
the product was purchased. They can take this product for environmental
safe recycling.
Clean these little holes.
Clean the water tank and the
water pump.
Use the water filter or water
purifier to soften or filter the
water.
Clean the water tank, and
change with new water.
Clean the water dividing
pipe, make sure all nine
holes are unclogged.
Move the unit to low
temperature space, or
lengthen the time of each ice
making cycle.
Make sure there is more
than 20CM space between
the unit back & front and the
obstacle.
Reduce the time of each ice
making cycle.
Take out some ice cube.
Move to the place with
temperature lower than 32
centigrade, and change to
the low temperature water.
Need the technical
serviceman to maintain.
Need the technical
serviceman to maintain.
26