HOMCOM 800-254V70 Bedienungsanleitung Seite 26

EN
NORMAL TROUBLE SHOOTING
Problem
The whole " " symbol
is always on.
The unit enter the ice
making process, but no
water flowing in the unit,
and the whole "
symbol is on.
Possible Cause
No water in unit
Floating ball of the water level
detecting switch is blocked, can't
be raised up.
Water flows out from the side of
the water tank.
Water flows out from the water
drain pipe of
No water in water charging tank,
or the water supplying problem,
or the silicone pipe of water tank
"
isn't on the correct position.
When automatic water
supplying way, maybe the
main water pressure is too
low or the water supplying
hose is blocked. Check them
and increasing the water
pressure and clean the
supplying hose. When using
manual water supplying way,
maybe there is no water in
water charging tank, fill the
water into the water
charging tank to MAX water
level.
Clean the water tank and the
water level detecting switch.
Place the unit on the level
position, not on the slope.
Pull out the pipe and install
back to the right-side slot of
the water tank.
the water tank properly.
When automatic water
supplying way, maybe the
main water pressure is too
low or the water supplying
hose is blocked.
Check them and increasing
the water pressure and
clean the supplying hose.
When using manual water
supplying way, maybe there
is no water in water charging
tank, fill the water into the
water charging tank to MAX
water level.
The silicone pipe of water
tank should be clamped in
the slot of the water tank
side.
25
Solution