HOMCOM 800-254V70 Bedienungsanleitung Seite 17

EN
3. When the ice-making process is over, then switch to ice-harvest process. During the ice-
harvest process, the ICE cube symbol change rotating to flash. At same time, the arrow on
the manual filling water symbol will start to flash, the water will flow into the water tank
again till the floating ball of water level switch rises up to the highest position, then the
water stops flowing and the whole manual filling water symbol will disappear.
When the ice-harvest finish, the Ice-full detecting plate will rotate downward once, then
recover to the original position and enter to the next ice-making process.
If after the rotation of the Ice-full detecting plate, it is pressed by the ice cube and can't
recover to the original position, means the ice bin is full of the ice cube and it will stop
making the ice automatically.
4. When the "ICE-FULL" symbol display is on, the unit stops running. And if you move away
the ice cube, the unit will start to make the ice cube again. But it will restart only after 3
minutes interval of compressor running.
5. During the ice-making process, press the "+" or "-" button to adjust the ice- making process
duration period length, then to change the thickness of the ice cube. Press the "+" or "-"
button, the right digit will flash, the default setting is zero, 1 minute will add or decrease to
each ice making process per each pressing of "+" or "-" button.
After 5 second of setting, the new setting will be remembered by the system.
6. The bad water quality will cause the bad quality of ice cube, and reduce the transparency
of the ice cube.
Automatic self-cleaning program
Start the self-cleaning program:
After connecting all of the water pipe, plug on the main power supply plug, then press "TIMER
/CLEAN" button on control panel for more than 5 seconds, to enter the Self-Cleaning program.
And the " " symbol will always be on during this period, the left digit will indicate the left
time. The total duration time is 20 minutes for one self-cleaning program.
Cancel the self-cleaning program:
It takes about 20 minutes to complete one self-cleaning program. When the program is over,
the system will be in standby mode automatically. And also, you can press the "ON/OFF"
button on control panel to cancel the self-cleaning program by force.
Timer setting operation
Delay time range: 1-24 hours, Default time: 1 hour
How to set the ON-Timer: During the unit is in standby mode, press the "TIMER/CLEAN"
button to set the ON-Timer. The "
the symbol will flash to display the set delay time. During the number flashing, press "+" "-"
button to change the delay time of the timer, 1 hour increasing or decreasing per each
pressing of "+" or "-" button. Five seconds after setting, your desired setting will be
remembered.
" symbol will start to be on, the number "1" above
16