HOMCOM 800-254V70 Bedienungsanleitung Seite 23

EN
Ice Making Assembly System Cleaning by Using Nu-Calgon Nickle Safe Ice-machine
Cleaner (Better using automatic water supplying)
Minerals that are removed from water during the freezing cycle will eventually form a hard
scaly deposit in the water system. Cleaning the system regularly helps remove the mineral
scale buildup. How often you need to clean the system depends upon how hard your water
is. With hard water of 4 to 5 grains/liter, you may need to clean the system as often as every
6 months.
1. Turn off the ice maker. Keep the ice maker connect to the main water supply and
drainpipe. But shut off the water faucet of main water supply.
2. Open the door and scoop out all of the ice cubes. Either discard them or save them in an
ice chest or cooler.
3. Making the cleaning solution. Please mix the Nu-Calgon Nickle Safe Ice Machine Cleaner
with water to make the cleaning solution.
Wear rubber gloves and safety goggles (and/or face shield) when handing Ice
Machine Cleaner or sanitizer.
Use a plastic or stainless container with more than 4 liters capacity, mix 300 ml Nu-Calgon
Nickle Safe Ice-machine Cleaner with 2.8 liters warm water about 50-60 ℃.
Then divide them for 2 shares equally in 2 cups. It is better to keep the temperature of each
cup of the cleaning solution.
4. Check to be sure that the water drain pipe of the water tank has been installed properly in
the slot of the tank wall. Then Pour one cup of Nickel- Safe Ice Maker Cleaning Solution into
the water tank. Wait about for 5 minutes.
5. Turn on the power to the ice maker, then press "TIMER/ CLEAN" button on control panel
for more than 5 seconds, to enter the self-Cleaning program. Same as above explanation,
the water pump runs for 8 minutes and stops for 3 minutes, one cycle, again one cycle.
The total duration time is 20 minutes for one self-cleaning program.
During this process, the "
window will indicate the left time.
WARNING
" symbol will always be on during this period, and the digit
22