HOMCOM 800-254V70 Bedienungsanleitung Seite 13

EN
be replaced, it should be done by a qualified service engineer.
This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good grounding
means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is equipped
with a power supply cord having a grounding plug. To minimize possible shock hazard, the
cord must be plugged into a mating grounding-type wall receptacle, grounded in accordance
with the National Electrical Code and local codes and ordinances. If a mating wall receptacle
is not available, it is the personal responsibility of the customer to have a properly grounding
wall receptacle installed by a qualified electrician.
CLEANING YOUR ICE MAKER BEFROE FIRST USING
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Open the ice taking door.
2. Clean with diluted detergent, warm water and a soft cloth.
3. Repeatedly clean the water contacting inner parts, use the water or the wet clothe to scrub
the relevant parts, then use the dry cloth to dry them.
4. You can pull the Water drain pipe of the water tank indicating "H" in above illustration to drain
out the cleaned water in the water tank, then next to clean inner ice-storing bin, till all of
inner parts are cleanly, then drain out all of the cleaned water from the water drain port
located at unit back indicating "8"in above illustration. And must to install back the water
drain pipe of the water tank and the cap of the unit water drain port, otherwise, the unit will
not make the ice normally.
And suggest that you should discard the ice-cube made by the first ice making cycle
after cleaning.
Note: Please see the section "Water Drainage" in this manual to drain out the cleaned water.
5. The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
6. Dry the interior and exterior with a clean soft cloth.
OPERATION YOUR UNIT
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to connect to water
mains and that old hose-sets should not be reused.
1. Connect the water supplying hose to the unit (For automatic water supplying)
Step 1: First remove the tape on the water inlet port for water supply (indicated in the
following illustration "B") located at unit back, then use your other hand's finger to press the
12