Setting The Time - Steca StecaGrid 3000 Installations- Und Bedienungsanleitung

EN

Setting the time

Setting the country and reactive power characteristic curve
70
4. Press SET briefly. The day flashes.
5. Press  to change the day.
6. Press SET briefly. The change is adopted.
7. Press . The month is selected.
8. Repeat steps 4 to 6 for the month.
9. Press . The year is selected.
10. Repeat steps 4 to 6 for the year.
11. Press SET for a longer time.
1. Press  to select a time format.
2. Press SET briefly. The time format is adopted.
3. Press SET for a longer time.
4. Press SET briefly. The hours display flashes.
5. Press  to change the hour.
6. Press SET briefly. The change is adopted.
7. Press . The minutes are selected.
8. Repeat steps 4 to 6 for the minutes.
9. Press SET for a longer time.
Note
The country can only be set once!
1. Press  to select a country.
2. Press SET briefly.
3. Press SET for a longer time.
If a reactive power characteristic curve is not prescribed
for the selected country then finish initial commission-
ing (see below).
4. Press  to select the reactive power characteristic
curve according to the local regulations.
5. Press SET briefly. The characteristic curve is adopted.
6. Press SET for a longer time. If in step 4 Default char.
curve or Char. curve cos φ = 1 was selected then
proceed with step 18.
7. Press SET briefly. The setting value flashes.
8. Press  to change the number of nodes.
9. Press SET briefly. The value is adopted.
10. Press SET for a longer time.
746.217 | 12.27