O) Selecting The Signal For Valid User Code Or Valid Transponder - Renkforce IP65 Bedienungsanleitung

o) Selecting the Signal for Valid User Code or Valid Transponder

When the code lock has recognised a valid user code or a valid transponder, the associated
output is activated.
Additionally, the code lock may output a sound signal; this may also be switched off, however.
In the default setting, the code lock will emit one long sound signal. Usually, this is used
to signal function of the door opener (this is particularly sensible in door openers that
only make low sounds when activated).
Proceed as follows to select signalling:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Select the desired function:
No signalling
One long signal sound (1 second), default setting
Two brief signal sounds
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
.
button.
105