C) Controlling (Opening Or Closing) The Relay With The Superuser Code; D) Keeping The Relay Open With The Superuser Code - Renkforce 1582597 Bedienungsanleitung

c) Controlling (opening or closing) the relay with the superuser
code
You can use the superuser code like a standard user code to open the door
2 5 8 0
#
1

d) Keeping the relay open with the superuser code

The relay opens when you enter a user/guest code. In certain circumstances, it may be
necessary to keep the relay open to grant access to people without needing to enter a code.
The superuser code can be used to control access to the secure area.
This function is only recommended for fail-safe locks. Using this function with fail-
secure locks is not recommended, as this may damage the lock if it stays activated for
too long and consumes a large amount of power.
To enable this function, proceed as follows:
2 5 8 0
#
7
74
Enter the superuser code (in this example, the superuser code is "2580")
and press the # key. The yellow LED will start to flash more rapidly. Press
"1" to confirm your entry.
The yellow and green LED will turn on and the code lock will beep to
indicate that the door is open. The relay will open the connected device
(e.g. door opener). The green LED will stay turned on while the relay is
activated.
In toggle mode, the connected device stays open. Repeat the same entry
to disable the relay.
In normal mode, the relay switches back to its initial position after the
preset time has elapsed.
Enter the superuser code (in this example, the superuser code is "2580")
and press the # key. The yellow LED will start to flash more rapidly. Press
"7" to confirm your entry.
The relay will open the door. The green LED will stay on while the door
is open.
To close the relay, use the same sequence with the superuser code. The
green LED will turn off and the door will be locked.