Renkforce IP65 Bedienungsanleitung Seite 113

Saving the transponder and secondary code for user #3
Enter the following programming:
(a) (b)
(a) Output #1 is to be switched
(b) Access via transponder + subsequent input of the secondary code
(c) Memory slot number "003" (output #1 can use: 000 - 999)
(d) Hold transponder in front of the sensor surface (distance < 2 cm)
(e) Enter secondary code
(f) Save programming (code lock emits two beeps)
Setting the activation duration for output #1 (with connected door opener) to 3 seconds
Enter the following programming:
(a) (b)
(a) Start programming for activation duration of output #1
(b) Set duration (timer) to 3 seconds
(c) Save programming (code lock emits two beeps)
Terminating programming mode
• Briefly push the star button twice.
• The code lock emits two beeps and the LED (1) at the upper left of the code lock will flash
slowly (orange).
Programming mode is ended; the code lock is in regular operation.
(Reading transponder)
(c)
(c)
(d) (e) (f)
113