N) Switching The Signal Sounds Of The Code Lock On/Off - Renkforce IP65 Bedienungsanleitung

n) Switching the Signal Sounds of the Code Lock On/Off

The code lock emits various signal sounds, e.g. one signal sound for confirming a valid user code
or a valid transponder, 5 sounds at invalid access attempts, etc.
These signal sounds may be very annoying (especially if there are many users of a code lock
or at night).
The signal sounds when switching on the code lock and the special warning sounds
cannot be deactivated for reasons of safety.
Proceed as follows to switch the signal sounds on/off:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Select the desired function:
Signal sounds off
Signal sounds on (default setting)
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
104
.
button.