L) Safety Functions At Wrong Input - Renkforce IP65 Bedienungsanleitung

l) Safety Functions at Wrong Input

You can programme in input lock to prevent trying out of many codes.
Proceed as follows for setting:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Select the desired function:
.....
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
While the input lock is active, the left LED (1) is lit permanently red (the LED briefly
flashes orange as usual, however, to display regular operation).
Ending input lock with the superuser code
When the input lock is active, you can terminate it prematurely with the superuser code so that
other persons can operate the code lock and activate the outputs.
Example: The superuser code was programmed to be "6789":
Example: Setting the input lock to 5 wrong inputs
(a) (b) (c)
(a) Start programming for the input lock
(b) Set the input lock to 5 wrong inputs
(c) Save programming (code lock emits two beeps)
102
.
After 10 wrong inputs (user code or transponder), the code lock will be locked
for 60 seconds (default setting).
After 5 to 10 wrong inputs (user code or transponder), the code lock will be
locked for 15 minutes.
The safety function/code lock is deactivated.
button.
Ending input lock