Turning Off The Device - Hms Loop10 Bedienungsanleitung

DISPLAY WINDOWS
Function
Time
Distance
Calories
Speed

TURNING OFF THE DEVICE

•
The treadmill can be turned off at any time by disconnecting the power supply — this will not damage the equipment.
Technical notes
•
Before starting your workout, ensure that the power is turned on.
•
If you encounter any problems with the device, please contact your retailer.
•
Persons without technical qualifications should not attempt to dismantle or repair the treadmill.
Safety precautions during exercise
• Before starting your training, consult a specialist who will select the appropriate intensity, frequency and duration of your exercise.
• In case of chest pain, shortness of breath, dizziness, irregular heartbeat or other discomfort, stop exercising immediately and consult a
doctor.
Cleaning and maintenance
•
Always disconnect the power cord before cleaning.
•
Regularly remove dust from the components and exposed parts on the sides of the treadmill.
•
Ensure that your exercise footwear is clean — this prevents the transfer of dirt.
•
Clean the treadmill belt with a damp cloth and soapy water, avoiding contact with electrical components.
Warnings
• Always disconnect the power supply before removing the motor cover.
• The motor cover should be opened at least once a year to remove dust.
Lubricating the treadmill
•
The treadmill belt is lubricated at the factory.
•
Friction between the belt and the platform affects the service life and performance of the device — lubrication is necessary.
•
Check the condition of the belt regularly. If damaged, contact a service centre.
Lubrication schedule:
•
We recommend purchasing lubricating oil from local dealers or directly from our company.
Additional tips
•
After 2 hours of continuous use, switch off the power and leave the treadmill running at idle speed for 10 minutes.
•
A belt that is too loose may slip; one that is too tight puts strain on the motor and increases roller wear.
• Optimal tension: the belt can be raised by 50–75 mm on each side.
Tension adjustment and belt centring Belt centring:
1. If the belt moves to the right (A):
Disconnect the power supply.
o
Turn the right adjustment screw ¼ turn clockwise.
o
Connect the power supply and check the
o
alignment. If the belt shifts to the left (B):
Disconnect the power supply.
o
Turn the left adjustment screw ¼ turn clockwise.
o
Connect the power supply and check the alignment.
o
2. Repeat the operation until the belt is centred.
Tension adjustment (C):
1. Disconnect the power supply.
2. Turn the left and right adjustment screws simultaneously ¼ turn clockwise.
3. Connect the power supply and safety key.
4. Start the treadmill and stand on the belt to check the tension.
5. Repeat the operation until the correct tension is achieved.
Value range
0:00–99:59
0.00–99.90 km
0–9999 kcal
0.8–6 km/h (metric)
Intensity of use
< 3 hours/week
3–5 hours/week
> 5 hours/week
Comments
Resets to zero when exceeded
Reset when full
Reset after overflow
0.5–3.8 miles/h (imperial)
Lubrication frequency
Once a year
Every 6 months
Every 3 months
7
EN