Start Up - Spengler Neotens Neo300 Gebrauchsanweisung

UNIT OPERATION

START UP

1. Power On
Press and hold " " button for at least 2 secondes then release the button, to turn the unit on. A beep is emitted. The LCD
screen is displayed for 1 second when the device performs a quick diagnosis.
2. Display Revision
The LCD screen continues to display the identifiers of hardware and firmware revisions onto the SYS and DIA LCD segments
respectively during one second. Fig.1 shows hardware version V.1.0 and firmware version V.1.0.
Fig.1
NOTE: The user shall systematically check at device start, that all LCD segments
light up and that one short bip is emitted. In the event of a defect, the product
shall be returned for immediate service.
USER MANUAL NEOTENS | WWW.SPENGLER.FR
3. Steady state
The unit continues to enter into steady
state, and it wait for user pressing any key
to start a new operation.
EN
45