Start Up - Spengler Neotens Nomad Neo100 Gebrauchsanweisung

Start up

1. Power On
Press and hold " " button for more than 2 seconds then release the button to turn
on the device. A beep is emitted. The LCD screen is displayed for 1 second when the
device performs a quick diagnosis.
2. Display Revision
The LCD screen continues to display the hardware and
firmware revision identifiers on the SYS and DIA segments,
respectively, for one second. For example, the following
image shows that hardware and firmware revisions are
V1.0 and V1.0.
3. Steady state
The unit continues to enter into steady state, and it wait
for user pressing any key to start a new operation.
58
MANUEL UTILISATEUR NEOTENS NOMAD | WWW.SPENGLER.FR
NOTE: The user should systematically check that
all LCD segments light up and that one short
beep is emitted when starting the device. In the
event of a defect, the product shall be returned
for immediate service.