Check Gearbox Oil; Storage; Disposal; Trouble Shooting - Zipper Zi-Rd300 Betriebsanleitung

14.2.7 Check gearbox oil

The gearbox is pre-lubricated and sealed at the factory. Unless there is evidence of leakage or ser-
vice has been performed on the gearbox, no additional lubricate should be required until 50 hours
of use.
For future use, check the oil level after every 50 hours of use.
If you remove the oil level plug and no oil flows out, please add oil and then screw the oil level plug.
NOTE: recommended motor oil: see technical data. Do not use synthetic oil! Capacity: see technical
data.
If you want to replace oil, place the machine on a level ground. The machine must be stopped and
still warm. Unscrew the filter cap and the drain plug. When the oil is drained, replace the drain plug,
fill up with fresh oil and then replace the filter cap.
14.3

Storage

Store the cleaned machine in a dry, frost-proof and lockable place when not in use. Make sure that
unauthorised persons and especially children do not have access to the machine.
If the machine is stored for longer than 30 days:

Let the machine cool down

Clean the machine and dry

Empty Tank and carburetor completely, avoid fuel spillage

Store in a dry, out of reach of children place, well packaged
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!

14.4 Disposal

Observe the national waste disposal regulations. Never dispose of the machine, machine
components or operating equipment in the residual waste. If necessary, contact your local
authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
15

TROUBLE SHOOTING

If you are unable to carry out the necessary repairs properly and/or do not have the required train-
ing, always consult a specialist to solve the problem.
Trouble
engine will not start
engine starts and is stalled
immediately
machine works with inter-
ruptions
machine does not work with
full performance
machine does not run
while the engine is run-
ning
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
N O T E
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
N O T E
Possible cause

incorrect starting sequence

dirty air filter

no fuel supply

fault in the fuel line

engine flooded.

spark plug connector not
placed on

no ignition spark

incorrect idle adjustment

carburetor incorrectly adjusted

spark plug fouled

machine overloaded

dirty air filter

carburetor incorrectly adjusted

gear is not engaged properly
TROUBLE SHOOTING
Trouble

observe the correct starting se-
quence

clean/replace air filter

refuel

check the fuel line for kinks or
damages

screw off, clean and dry the spark
plug. Then pull the cranking rope
several times and reinstall the
spark plug

place on the spark plug connector

clean/replace spark plug

check ignition cable

contact customer service

contact customer service

clean/replace spark plug

check spark plug connector

too much pressure

soil too tough

clean/replace air filter

contact customer service

shift lever in right position switch
34
ZI-RD300