Start Up; Checking The Engine Oil Level; Refuel; Operation - Zipper Zi-Rd300 Betriebsanleitung

13.3

Start up

13.3.1

Checking the engine oil level

ATTENTION! For transport motor oil has been drained. Fill up with 4-stroke quality motor
oil before first operation! Failure to do so will result in permanent motor damage and void
guarantee!
A too low oil level will cause damage to the engine and shorten the service life of the
machine. Therefore, check the motor oil level before every start and if necessary fill up
with oil.
13.3.2

Refuel

13.4

Operation

13.4.1

Start Engine

Start the engine, if you have your wheeled dumper mounted correctly:

Set the gear selection lever (7) to the neutral position.

Move the choke lever on the machine to the full choke position.

Turn engine switch to "ON".

Pull the starter rope several times so that the carburettor is filled with gasoline.

Pull the starter handle, pull-out until resistance is felt. Let the rope rewind slowly across and
then move expeditiously.

Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
Set the choke lever after a few seconds of engine run position ˝OPEN˝

To start the engine is warm the choke lever is not to be operated.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
3. After tipping the load, swing handle A back to reset limiter B
into hook C, which will lock the dump box.
NOTE: Before start operating, check the dump box to make sure
it is locked (B, C)!
W A R N I N G
1. To check the engine oil level, place the machine on a flat, level surface.
Switch off the motor and wait for ten minutes to allow the circulating oil
to collect in the oil pan.
2. Unscrew the oil-dipstick and wipe with a clean, lint-free cloth or a non-fi-
brous paper towel.
3. Push the dipstick back into the opening as far as possible, but do not
screw it in. (Make sure that the dipstick is really pushed in completely -
occasionally it gets jammed).
4. Pull out the oil dipstick again and check the oil level. There are two mark-
ings for this - see illustration on the left.
5. If the oil level is low, fill up the recommended oil to the upper rim at the
maximum (maximum filling volume: see technical data)
6. Insert the oil dipstick again and retighten it.
7. Wipe away oil residues.
W A R N I N G
Use only unleaded fuel with min. 95 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE
1. Refuelling only outdoors!
2. Before removing the filler cap, turn the engine off and let it cool machine
3. Clean the fuel filler cap area
4. Remove the filler cap carefully
5. Fill in fuel
6. Fuel tank capacity: see technical data. Fill tank only up to 1,5 cm below
the rim of the filler neck, so that the fuel has place for expansion.
7. Replace and tighten the filler cap
8. Wipe any fuel residues and wait until it evaporates
N O T E
OPERATION
31
ZI-RD300