Operation; Operation Instructions; Functions Of Components - Zipper Zi-Rd300 Betriebsanleitung

13

OPERATION

Only operate the machine when it is in a perfect condition. Before each operation, a visual inspec-
tion of the machine must be carried out. Safety devices and operating elements must be checked
carefully. Check screw connections for damage and tight fit. Replace any damaged parts before op-
erating the device.
13.1

Operation instructions


Disengage clutch lever before starting the engine

Always hold the machine with both hands when operating

Do not rapidly accelerate, turn sharply or stop

Do not overload the machine capacity
 Always make certain that the weight is evenly balanced
 Always move in directions parallel with the slope (up or down)

Change the gears only when the machine stands still
 To avoid danger, do not shift gears on slopes
 Attention: While tipping the centre of gravity will change suddenly

Do not tipping on soft ground
13.2

Functions of components

1 Engine switch: The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
2 Throttle control: Controls engine speed. Put the throttle control on low speed (L) or high speed
(H)
3 Right steering lever: Operate the lever to turn right
4 Clutch control lever: Squeeze the lever, clutch engaged. Release the lever, clutch disengaged
5 Left steering lever: Operate the lever to turn left
7 Gear selection lever: Controls forward (3x) or reverse (1x) movements of the machine.
8 Tipping handle: Controls the tipping of the dump box (manual!)
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
B Handle frame:
Mount the handle frame assembly to the chasis and secure
it with M10X25 bolts, washers and nuts at the front and
M10X45 bolts, washers and nuts at the rear.
C Dump box:
Install the dump box and fasten the front with two Ø4 R-clips.
N O T E
1. Swing tipping handle A in the direction of the arrow to re-
lease limiter B out of hook C. The dump box will be released.
2. Tipping by han
OPERATION
30
ZI-RD300