Engine; Engine Oil Exchange; Clutch; Steering - Zipper Zi-Rd300 Betriebsanleitung

every 25 operating hours
every 20-30 operating hours
every 50 operating hours
14.2.2

Engine

Information about engine maintenance you can find in operation manual of the engine manufac-
turer!
14.2.3

Engine oil exchange

The engine oil change would be explicitly mentioned here in order to be included in the machine
operating manual. Oil change interval after the first 20h or 1 month after commissioning and then
every 100h or 1x per year.

14.2.4 Clutch

As clutch wears out, the same lever could have a wider opening, being so uneasy to use. To enable
proper operation, the clutch cable must be adjusted:
14.2.5

Steering

If you have difficulty steering the unit, you will need to adjust the steering levers with the special ad-
justers.
If the above adjustment does not create enough cable tension, follow the steps below:

14.2.6 Tires

Check the pressure of tires periodically to make sure they are properly inflated.
Recommended pressure is: 2,1 bar (0,21Mpa)
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
spark plug
air filter
oil level
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
1. Remove the oil drain plug (1) from the engine.
2. Open the oil tank cap (2). Collect the draining oil in a collection con-
tainer and dispose of it properly.
3. Retighten the oil drain plug after draining.
4. Fill in fresh oil through the filling opening (3) (see section Checking
Drain the used oil when the engine is warm. Warm oil
drains quickly and completely.
the engine oil level).
Use only high quality engine oil, e.g: SAE30, 15W40 or similar!
1. Loosen the jam nut (1) by turning it counter clockwise with 10 mm
wrench.
2. The clutch lever is set to the original position with the adjusting nut
(2).
3. Then retighten the lock nut (1).
1. Loosen the jam nut (3) by turning it counter clockwise with 10 mm
wrench.
2. Unscrew the adjust nut (4) to eliminate the play in the cable, which
can occur after initial use or normal wear. Be very careful not to un-
screw the adjust nut too much because this can create another prob-
lem: the loss of traction.
3. Then retighten the lock nut (3).
1. Loosen the jam nut (5) by turning it counter clockwise with 10 mm
wrench.
2. Unscrew the adjustment nut (6) to eliminate the play in the cable. (do
not to unscrew the adjust nut too much because this can create an-
other problem: the loss of traction).
3. Retighten the lock nut (5).
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
clean
clean
check
N O T E
N O T E
33
ZI-RD300