Symbols Used In The Operating Instructions - Dantherm Rcc 130 Bedienungsanleitung

Symbols used in the operating instructions

Signal words
Hazard symbols
6
In these operating instructions, particularly important text passages are highlighted with
signal words and symbols that are described below.
DANGER
...indicates a hazard which, if not avoided, will result in death or serious injury.
WARNING
...indicates a hazard which, if not avoided, could result in death or serious injury.
CAUTION
...indicates a hazard which, if not avoided, could result in a minor or moderate injury.
NOTICE
...indicates important information (e.g. property damage) but does not indicate hazards.
INFO
Information marked with this symbol helps you to carry out your tasks quickly and safely.
This symbol is used to warn you of potential risk of injuries. Follow all safety instructions
indicated in the manual next to the warning triangle to avoid potential injury or death.
Electrical voltage!
This symbol indicates that there are dangers to the life and health of persons due to electrical
voltage when handling the system.
Sharp element
This symbol indicates that there is a risk of injuring your hands on a sharp element when
carrying out certain work.
No reaching in
This symbol indicates that it is forbidden to reach into certain components of the unit with
your hands.
Protective gloves
This symbol indicates that it is required to wear protective gloves when performing a specific
operation.
Protective mask
This symbol indicates that it is required to wear a protective mask when performing a specific
operation.
Disconnect mains plug from electrical outlet
This symbol indicates that you have to remove the power plug from the socket before
carrying out certain work.
Introduction: Symbols used in the operating instructions