Dantherm RCC 130 Bedienungsanleitung Seite 36

Change-over to
operating mode B
36
If local systems require operating mode B, follow the procedure below and check the
information on the label to connect the water drain properly.
1. Loosen the two screws securing the control unit to the unit.
2. Pull the control unit all the way out of the unit until reaching the stop.
1
Fig. 22: Temporarily pulling out the control unit
ð You can now access the control unit's main PCB.
3. The main PCB is equipped with a switch that can be used to change the operating mode.
By default, operating mode A is set as depicted in the figure. Slide the switch to the right
to select operating mode B.
Fig. 23: Changing the operating mode
4. Push the control unit back into the unit and fasten it with the two screws.
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
2
3
A B
Installation: Installation options