Accessories - Dantherm Rcc 130 Bedienungsanleitung

Accessories

Electric
preheating
Hand-held remote
control
Wired remote
control (HCP 11)
Accessory control
(HAC 2)
24
The unit is delivered ex-factory without any optional accessories mounted. The accessories are
to be mounted prior to initial unit installation, or, if required, after start-up, if additional
functionality is requested. For the installation of the accessories, please refer to the
instructions supplied with each accessory.
The unit can be equipped with an electrical preheating element that preheats the incoming
air. The preheater increases the temperature of the outdoor air supplied to the heat
exchanger. This way, the risk of ice formation inside the heat exchanger is reduced during
operation in very cold weather conditions.
The preheater is an external device that is connected to and controlled by the control unit of
the RCC.
To control the RCC, Dantherm recommends using a remote control specifically designed for
this unit series.
Fig. 9: Hand-held remote control
A wired remote control (HCP 11) without display can be connected to the unit as an
alternative to the hand-held remote control.
Fig. 10: Wired remote control HCP 11
A variety of accessories can be connected to the unit via the accessory control HAC 2.
Fig. 11: Accessory control HAC 2
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Product description: Accessories