INSTALLATION AND SERVICE
MANUAL FOR PROFESSIONALS
Overview
Introduction
Target group
Safety
precautions
Safety
18
This part of the manual is intended for use by suitably qualified personnel only.
It is essential to be familiar with the correct operating procedure of the residential ventilation
system and all safety measures. Dantherm accepts no liability for operational failures or
personal injury resulting from the failure to comply with safety measures.
Observe the following safety instructions:
• Do not use the unit in potentially explosive rooms or areas and do not install it there.
• Ensure that all electric cables outside of the unit are protected from damage (e.g. caused
by animals). Never use the unit if electric cables or the power connection are damaged!
• Only plug the power plug into a properly fused (earthed) mains socket.
• Only install the unit in accordance with the national regulations for electrical connection.
• Prevent dust, dirt and moisture from entering the unit during the construction phase by
blocking all air ducts and inlets to the unit.
• Do not operate the unit until the house is clean and habitable.
• Observe the operating conditions specified in the "Technical data" chapter.
• Do not cover any air intakes or outlets at any point – except with accessories intended for
this purpose.
• Before carrying out maintenance, care or repair work on the unit, remove the power plug
from the mains socket. When doing so, pull the plug, not the cable.
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Overview: Introduction