Dantherm RCC 130 Bedienungsanleitung Seite 54

Inspecting and
cleaning the heat
exchanger
54
1. Check the heat exchanger for dust and dirt. Clean all four inlets of the heat exchanger
with a soft brush and a vacuum cleaner. In special circumstances (e.g. if there are signs of
accumulated, dirty condensate in the heat exchanger), the heat exchanger may need to
be removed from the unit and cleaned with soapy water.
2. To remove the heat exchanger, turn the four locks by 90°.
Fig. 49: Opening the heat exchanger locks
3. Lift the heat exchanger out of the unit and clean it.
Fig. 50: Removing and cleaning the heat exchanger
INFO
Ensure correct alignment when reinstalling the heat exchanger. There is a seal on the T-
profile, which must face the machine.
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Maintenance and troubleshooting: Cleaning the interior of the unit