Dantherm RCC 130 Bedienungsanleitung Seite 38

Air duct
connections
38
8. Attach a new B label and a calibration label on the unit.
9. Connect the air duct as indicated on the label and described on page 44.
10. Calibrate the unit as described on page 47.
By default, only the duct connections on the shorter sides of the unit are open. The inlets and
outlets of the airflows in the two operating modes are depicted in the figures below.
Colour (arrows)
green
red
yellow
brown
Fig. 25: Airflows in mode A
Fig. 26: Airflows in mode B
The ducts on the long sides of the unit are sealed by default, but can optionally be opened to
allow further connection options. When using the air duct connections on the longer side, the
unused air duct connections must be sealed (see page 40).
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Designation of the airflow
T1
T2
T3
T4
Installation: Installation options
Description
Outdoor air
Supply air
Extract air
Exhaust air