Dantherm RCC 130 Bedienungsanleitung Seite 11

USER MANUAL
Operation: Temporary operating modes (override)
If bypass/cooling is desired and the automatic bypass function is not activated, the bypass
Manual bypass
can be activated manually.
function
The bypass is opened once the conditions for manual bypass are met within the set time
period (default setting: six hours). The time period can be changed by means of the PC Tool.
Briefly pressing the bypass button activates/deactivates the manual bypass mode.
An active bypass mode (open damper) is indicated by the continuous illumination of the
corresponding LED.
Note: If the bypass mode is activated but the conditions for the open bypass damper are
not met, the activated bypass mode is not indicated by the LED.
Conditions that must be met to activate the automatic bypass function:
• The outdoor temperature is at least 2 °C below the extract air temperature
• AND the outdoor temperature is above 9 °C
In summer mode, the supply air fan is stopped so that only the extract air fan is operating. In
Summer mode
this case, the fresh air supply is ensured by opening windows, doors, etc.
INFO
The summer mode is automatically deactivated once the outdoor temperature drops below
14 °C.
Pressing and holding the bypass button for five seconds will activate/deactivate the
summer mode.
When the summer mode is activated, this will be indicated by the corresponding LED
flashing.
Fireplace mode The fireplace mode can be activated when you light a fire in the fireplace. The unit will then
generate excess pressure for seven minutes to prevent the formation of smoke in the living
room. If the fireplace mode is not deactivated manually, it switches off automatically after
seven minutes.
INFO
The fireplace mode is only activated once the supply air temperature is above 9 °C.
Pressing and holding the fan speed button for five seconds will activate/deactivate the
fireplace mode.
When the fireplace mode is activated, this will be indicated by one of the three fan speed
LEDs flashing.
11