Dantherm RCC 130 Bedienungsanleitung Seite 33

INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: General requirements
If the unit is to be mounted vertically on the wall, T1 and T4 (cold air ducts) must always be
Space requirement
located at the bottom of the unit. Please allow enough space on both sides to screw the
for wall mounting
screws properly into the wall.
If the unit is to be fitted with an additional preheater, please observe the instructions for
fitting the preheater before installing the RCC. These can be found in the operating
instructions for the preheater.
INFO
The preheater is always placed on the same side as the filters of the RCC and must be taken
into account with regard to the space requirements of the unit.
Fig. 18: Space requirement for the preheater for wall mounting
INFO
For horizontal wall mounting, the unit must be installed with the control panel facing
upwards. The minimum distances for screwing in the screws are the same.
580
530
530
580
33