Dantherm RCC 130 Bedienungsanleitung Seite 35

INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: Installation options
The air ducts leading into the dwelling can either be connected to the right or left side.
Selection of the
Operating mode A is set as standard. (Carry out the steps in the Change-over to operating
operating mode
mode B section on page 36 to switch to operating mode B.)
Fig. 20: Connection of the air ducts in operating mode A
Fig. 21: Connection of the air ducts in operating mode B
Risk of electric shock!
You can be severely injured by an electric shock.
• Always disconnect the unit from the mains by removing the mains plug from the socket
NOTICE
Damage to the unit due to water accumulation
If the unit is mounted horizontally on the wall without being tilted, condensate may
accumulate and cause damages to the unit.
• Lower the side of the unit with the active condensate drain by at least 40 mm.
DANGER
before opening the unit!
35