Dantherm RCC 130 Bedienungsanleitung Seite 37

INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: Installation options
5. Swap the condensate drain (1) and plug (2) as indicated. For a detailed description of
6. To change the RH sensors, open the side panel and look for the "A" and "B" markings.
7. Change the filter (ONLY if the optional pollen filter ePM1 is used for the supply air). For
the installation of the condensation drain hose, see page 46.
1
Move the humidity sensor (and the VOC sensor, if installed) to the position for operating
mode B.
1
Fig. 24: Positioning of the humidity sensor
1 Attaching the humidity sensor when
using operating mode A
information on the correct positioning of the ePM1 filter for operating mode A/B, please
refer to the table on page 20.
2
2
2 Attaching the humidity sensor when using
operating mode B
37