Dantherm RCC 130 Bedienungsanleitung Seite 43

INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: Assembly
Please proceed as follows to mount the unit horizontally on a wall:
Horizontal wall
mounting
1. Place the unit in a suitable position on the wall (see page 33).
2. When positioning the unit, ensure that the side of the unit with the active condensate
NOTICE
Damage to the unit due to water accumulation
If the unit is mounted horizontally on the wall without being tilted, condensate may
accumulate and cause damages to the unit.
• Lower the side of the unit with the active condensate drain by at least 40 mm.
3. Drill two holes into the left mounting bracket, insert the appropriate screws and tighten
4. Drill two holes into the right mounting bracket, insert the appropriate screws and
drain (left or right, depending on the operating mode) is positioned with an inclination
of at least 40 mm towards the floor.
Fig. 33: Horizontal wall mounting with inclination – mode A
Fig. 34: Horizontal wall mounting with inclination – mode B
them lightly.
tighten them lightly.
43