Scheppach KS1200 Originalbetriebsanleitung Seite 22

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise your-
self with your tool and to use it for its intended purpose.
The operating manual includes important instructions
for the safe, proper and economic operation of the
tool, for avoiding danger, for minimising repair costs
and downtimes and for increasing the reliability and
extending the service life of the tool.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the tool in your country.
Keep the operating manual package with the tool at all
times and store it in a plastic cover to protect it from
dirt and moisture. They must be read and carefully
observed by all operating personnel before starting
the work. The tool may only be used by personnel
who have been trained to use it and who have been
instructed with respect to the associated hazards. The
required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
22 | GB
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1/B/D/L)
1. Turntable, compl.
2. Support table
3a. Fixing screw
3b. Fixing screw
4. Chain stop
5. Guide plates
6. Guide rail
7. Locking nut
8. Adjusting screw (for grinding depth)
9. Grinding disc
10. Cover
11. Handle
12. On/off switch
13. Grinding head
14. Screws
15. Nut
16. Flange
17. Protective cover
3. Scope of delivery
• Tool sharpening station
• Turntable (1)
• Locking nut (7)
• Operating manual
• Open the packaging and carefully remove the device.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
www.scheppach.com