Scheppach KS1200 Originalbetriebsanleitung Seite 30

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
14. Possible faults
Fault
Tool sharpening station not
running
Tool sharpening station
grinds with interruptions
Grinding disc becomes hot
Engine hums, grinding disc
stays stationary
Unusual vibrations
30 | GB
Possible cause
• No power or power failure
• Extension cable faulty
• Mains plug, engine or switch
faulty
• Extension cable faulty
• Internal fault
• On/off switch defective
Grinding disc is blunt or defective
Grinding disc jammed
Grinding disc is defective
www.scheppach.com
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
range for the free collection of the old electrical de-
vice upon request from the end user. Please contact
the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
• Check power supply, socket, fuse
• Check extension cable, replace defective
cable immediately
• Have the engine or switch checked or
repaired by a licensed electrician or replaced
with original parts.
• Check extension cable, replace defective
cable immediately
• Please contact customer service for this
• Please contact customer service for this
Replace grinding disc
Remove object
Replace grinding disc