CAUTION
Hot surfaces!
Pumps can become very hot during operation.
Wear protective gloves or allow the pump to cool.
DANGER
Risk of slipping, falling and drowning!
Access steps can be wet and slippery. For this reason, a second person must always be available to monitor the
entry from the outside.
High physical and mental strain can occur during work in deep, confined or dark spaces. In addition, there is a risk
of falling.
Completely drain the system before entering it.
The system must be secured against further water inlet (install appropriate shut-off valves if necessary).
Prescribed personal protective equipment!
Always use personal protective equipment during installation, maintenance and disposal work on the system.
Protective clothing
Protective gloves
Safety footwear
Face protection
Operating and maintenance instructions must be kept available at the product.
NOTICE
Improper cleaning
Polymer components can become damaged or brittle
Clean polymer components only with water and a pH-neutral cleaning agent.
2.2
Personnel qualification
Competent expert / inspector: person employed by the owner-operator or a commissioned third party who, on the basis of
their training, knowledge and practical experience, can properly carry out inspections, is familiar with and understands the
operating instructions.
General inspector/competent skilled person: employees of independent companies or experts who are proven to have
the necessary expertise and technical equipment for operation, maintenance and inspection activities and work in accor-
dance with installation instructions and design standards.
Specialist company: a specialist company must have the necessary devices and equipment, as well as competent person-
nel.
Waste disposal company: a specialist waste management company
Qualified electrician: works in accordance with the national regulations for electrical safety
Authorised activities
In-house check / maintenance
Complete emptying and cleaning
inside, filling with water
Installation, replacement of com-
ponents, commissioning
Inspection of the system before
initial commissioning,
General inspection
Electrical installation
2.3
Intended use
The grease separator with spirally wound pipe separates grease, oil and sludge from domestic or commercial wastewater.
It is designed in accordance with EN 1825. The separated material can be drawn off / pumped away at any time and during
operation.
016-302E
Competent expert
General inspec-
tor/competent
skilled person
—
—
—
—
—
—
—
Installation and operating instructions
Person
Specialist
Waste dis-
company
posal company
—
—
—
—
—
—
—
—
Qualified
electrician
—
—
—
—
31 / 84