Flying The Model In; Range Test; The First Start; Trimming The Model - Reely Speedy Bedienungsanleitung

10. Flying the Model in

After you have checked the centre of gravity, the motor function and the direction of the deflections, your model is
ready for its first flight. However, we recommend you contact an experienced model airplane pilot or a model construc-
tion club in your area if you are not sure as how to fly in an airplane model properly.
If your remote control has a timer, set it to 3 minutes. After landing, check the remaining capacity of your rechargeable
battery and correct the timer time up or down as necessary.
a) Range Test
Before the first use, the flight battery and any rechargeable batteries in the transmitter have to be charged as in-
structed by the manufacturer. First perform a range test for the remote control system on the flight area. The precise
procedure for the range test can be taken from the documents of the remote control.
b) The First Start
It is recommended that you have someone assist you for the first start by holding the flight model at the bottom of the
fuselage in the area of the wing and releasing it upwind at a flat angle against the wind at full motor power.
Our advice: In order to be able to distinctly see the flight attitude of your model, you should stand at a short distance
behind the person assisting you and look into the flight direction of the starting model.
If the assembly has been carried out correctly, then the model should rise up quickly. Try to steer as little as possible.
Only steer the model if it changes its flight attitude by itself.
Attention!
When flying with the drive switched off, always observe sufficient flight speed. Pulling the elevator control
stick too far causes the model to slow down. It can turn to the front or side.
Therefore, fly at a sufficient safety height in the beginning in order to allow yourself to get used to the steering attitude
of the model. Do not fly too far in order to be able to clearly evaluate flight position at all times. Once you have the
model safely under control, you can perform further optimisation.
c) Trimming the Model
Trimming is set while gliding with the motor off. If your model tends to drift to one side in straight flight, correct the
neutral position of the corresponding rudder by trimming. After you have adjusted the trim and your model is flying
straight, you can check the centre of gravity.
46