Servo Reserve And Motor Deactivation; Servo Reverse - Reely Super Cub Bedienungsanleitung

14.

Servo Reserve and Motor Deactivation

a) Servo Reverse
After a transmitter interference, or when replacing the transmitter, for example, you may need to change the control
direction of the rudder and/or elevator (servo reverse).
Changing control direction:
1. If the control direction of the rudder control is to be changed, push the right trim button of the rudder trim (1) with
the transmitter off. If you want to change the control direction of the elevator control, push the front trim button of
the elevator trim (2) with the transmitter off.
2. Switch the transmitter on with the trim button pushed (3). The trim button must be kept pushed.
The transmitter will issue a signal sound at an interval of one second after approx. 3 seconds. The function control
display at the transmitter (4) flashes at the same time. The respective control function now has been reversed in
its control direction.
3. Finally, check correct function of the remote control system.
Figure 7
41