Renewing The Transmitter/Receiver Binding - Reely Super Cub Bedienungsanleitung

12.

Renewing the Transmitter/Receiver Binding

To ensure that 2.4 GHz remote controls can transfer their signal without interference, the transmitter and receiver must
have the same digital code. Alignment of the digital encoding (binding between transmitter and receiver) is performed
with the binding function.
Transmitter and receiver are usually already aligned with each other or bound in the factory and can be used at
once.
Binding only needs to be performed again after replacing the transmitter or receiver or to remove malfunctions.
Since different manufacturers use different encoding methods, transmitter and receiver cannot be combined and
operated with products of other manufacturers.
Re-establishing the binding:
1. Push onto the left control lever (1) from the top with the transmitter switched off until you hear or feel a click and
hold it in this position.
2. Switch on the transmitter with the control lever pushed (2) and then release the control lever. The transmitter
switches to binding mode and issues a signal sound at a rhythm of seconds for approx. 20 seconds. The function
control display at the transmitter (3) flashes at the same time.
3. Connect the flight battery (3) to the model during the binding phase of 20 seconds (see chapter above).
The LED in the model will be lit during binding. After the end of the 20 seconds, the binding phase is completed
and the transmitter and model enter regular operating conditions.
4. Check correct function of the remote control system and the flight model.
Figure 5
39