B) Checking The Transmitter's Power Supply - Reely Super Cub Bedienungsanleitung

b) Checking the Transmitter's Power Supply

When new batteries are inserted, switch on the transmitter with the function switch (see figure 1, item 5) for test purpo-
ses. For this, push the function switch from the left switch position „OFF" to the right switch position „ON".
To indicate correct voltage supply, the green function control lamp lights up (see figure 1, item 3), and the transmitter
issues a short signal.
If the power supply is no longer sufficient for proper operation of the transmitter, the green function indicator lamp
starts to flash and the transmitter emits warnings sounds in a quick sequence. In this case, stop operation of your
model as quickly as possible.
Insert new batteries for further operation of the transmitter.
Attention!
When the receiver electronics in the model plane have an integrated protection circuit to prevent unintended
start-up of the drive motor, you also need to make sure before any commissioning of the transmitter that the
control lever for the motor function (see figure 1, item 4) is in the „Motor off" position. For this purpose, the
control stick must be pushed down completely or pulled towards you as far as possible.
36