VEVOR STDB-10L Bedienungsanleitung Seite 4

standard only) .
• The use of liquid temperature can not be higher than 35℃ .
• prevent the water from running into the electrical outlet down the cord .
• Do not lift , carry, or pull the pump by the power cord .
• Do not replace the pump cord . stop using the pump if it sustains damage
(option for pump with safe low voltage) .
• Always use the transformer provided to run the water pump or consult
with your electrician before other transformer is
connected .
• Do not connect the transformer provided to other appliance.
• Always unplug the power transformer from the electrical outlet before any
cleaning and handling.
• Indoor use only. place the transformer away from fire , moisture & direct
sunlight. (option for pump with light)
• The supply cord cannot be replaced. If the cord is damaged the
appliance should be scrapped.
To clean the pump
• unplug the pump from electrical outlet. use a small soft brush or place it
underwater stream to remove debris.
To keep water clean
• periodically change water to prevent water from becoming sticky and
forming microorganisms.
Troubleshooting
if the pump fails to run, the following should be checked, · check the circuit
breaker, or try a different outlet to make sure that the pump is getting
electrical power. NOTE-Always disconnect the pump from electrical outlet
before checking.
• check the pump discharge and tubing for kinks and obstructions. · Algae
buildup can be flushed out with a garden hose.
WARNING !!! the water pump must be fully soaked or it will be damaged!
- 3 -