Truma Aventa compact Gebrauchsanweisung Seite 26

Initial start-up
1 2
8
9
11 12
Fig. 10
1 Automatic mode
2 Heating mode
3 Cooling mode
4
Circulation mode
5 Dehumidification mode
6 Target temperature (°C)
7
Ventilation level
8 Activity indicator, cooling / heating / ventilation
9 iNet X status
10 Fault code
11 Bluetooth status
12 Night mode
13 Time
14 Battery status
 The symbols in the display become visible
depending on the respective setting.
5.2 Other control panels
In addition to the Aventa 2.G remote control
(Bluetooth), the Aventa can also be controlled using the
following control panels:
Truma iNet X Panel, iNet X Pro Panel (optional)
•
Truma App via Truma iNet X Interface (optional)
•
Vehicle manufacturer's control unit (CAN bus)
•
Observe the relevant operating instructions for
operation.
26 EN
3 4 5
13 14
6 Initial start-up
6.1 Information about initial start-up
If a new or replacement remote control is required, it

must be paired with the air conditioning system.
6.2 Pairing the remote control with the
air conditioning system
Insert batteries in the remote control.

Press the pairing button on the air distributor.

 The pairing button on the air distributor starts to
flash.
6
Then press the pairing button on the remote control.

7
 When the pairing button on the air distributor lights
up continuously for 10 seconds, the remote control
10
is paired with the air conditioning system.
Aventa compact 2.G / Aventa compact plus 2.G
40091-01234 ∙ 00 ∙ 10/2024