Parkside Performance PBSPA 12 E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 21

Before operating the product,
o
check whether the accessory tool is
correctly positioned, i.e. centred in
the chuck .
[ 1 ]
The scre bits
[
o
according to their dimensions and
their shape. If you are uncertain,
al ays check hether the bit ts
tightly in the screw head without any
free play.
˜ Operation
˜ Gear selection
ATTENTION! Risk of product
m
damage!
Do not operate the gear
selector
[ 5 ]
come to a standstill.
( ig. D)
Change the gear by sliding the gear
o
selector forwards or backwards.
[ 5 ]
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
ATTENTION! Risk of product
m
damage!
Do not operate the rotation
direction switch
the product has come to a
standstill.
are labelled
]
until the product has
Screwing
Low
High
Drilling
High
Low
until
6 ] [
( ig. )
Change the direction of rotation
o
by pressing the rotation direction
switch towards the left or right.
[ 6 ]
When the rotation direction switch
o
is in the middle position the on/off
switch is locked.
8 ] [
˜ Tor ue control
(Fig. G)
The torque can be adjusted by turning
o
the torque sleeve
Small screws or soft materials: Select
o
a low level.
Large screws, hard materials or
o
removing screws: Select a high level.
For drilling operation: Turn the torque
o
sleeve to the
[ 4 ]
˜ Switching on and o
NOTE
The on/off s itch
u
locked.
( ig. )
Switching on: Press and hold the on/
o
off s itch .
8 ] [
Regulate the speed as required (see
"Speed control").
Switching o : elease the on/off
o
switch .
8 ] [
˜ Speed control
By using the on/off s itch
o
can progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
6 ] [
.
4 ] [
position.
cannot be
8 ] [
, you
8 ] [
Speed
Lower speed
Higher speed
GB 19